If you’re new but want to get the LED strip lights working correctly, the essential step in using the LED strip lights to connect with the proper power supply to make them light up.
The set-up procedures may vary depending on where you bought your LED strip and power supply. We’ll go over the most typical configurations below.
Most premium LED strips are low-voltage ones that require a power supply. Because it powers the LED strip, the power supply is often called an LED driver.
The power supply is called an LED transformer since it converts the mains 220VAC or 110VAC to 12V or 24V. Read this tiny content to know the proper guidance of how to power LED strip lights!
How do LED strips get power?
LED strips are more challenging to installation and setup than traditional incandescent light bulbs.
Because they run on low-voltage DC, they need a power supply that changes 120V or 240V AC (depending on where you live) into the voltage signal that LED strips can use.
Most LED strips can be set up to run on either 12V or 24V DC. The power needs to be changed into the right low-voltage DC signal when using a standard 120/240V AC power source, like a household wall outlet.
Most of the time and efficiently, this is done with a DC power supply.
How to connect LED strip Lights to Power Supply: Complete Guide
When it tends to come to led strip lights, most have a female 2.1mm connection point that makes it easy to connect them. All you have to do to get the led strips to work is plug them into your plug-in power supply.
Here, you have a choice between two good options. People who use power supplies that are hardwired have another choice. This connection is slightly different, and you’ll need to be more involved.
If your led strip light comes with a female 2.1mm plug, you might want to buy a 2.1mm male screw-in plug that you can attach to your power supply (check price) and plug in your led strips.
You may want to take the plug off the led strip to work with the bare wires. You can then connect to your power supply using wire nuts. You must buy a led strip splitter if you want to use more than one led strip from the same power source.
You only need to connect the led strips to the ends of your led splitter and plug your female connector into the male connector on your power supply. This will ensure that the power is spread evenly and that the lights work right.
Final Words
In the end, connecting LED strip lights to a power source is a simple task that can be done quickly with the right tools and little knowledge. Whether installing LED strips for backlighting or as part of a larger project to automate your home, the information in this article will help you ensure the installation goes smoothly and safely.